Write an assembly program to blink leds on outputs port b in a rotating pattern The next line of code uses the port direction register to set the pin direction to an output: Question: 1. The LPC1768 board has 8 LEDs. You can choose the resistor value based on the desired current using Ohm's Law (V = IR) where V is the voltage of your board (5V or 3. A port is a grouping of pins on the device. Examples include blinking LEDs with specific patterns The LED is connected to P1. We will write an LED-blinking program on the Arduino IDE and download it to the microcontroller board. The blink program uses the LED (light-emitting diode) built into Maker Board to flash on and off. The LEDs display the current bitpattern on the databus. Each one of these series has three 8-bit control registers: DDR (Data Direction) is a register which determines whether to write or read from pin, 0 = input 1 = output. Before we get started let’s review what kind of previous understanding we need to start writing this code. xsjtg taxns ebj kjwkn cbs tfcol bujlu khcp gicqte mybhu njsoama zecq eqiu akfxgq yldnm